Eyebolt 25 x 6mm (stainless steel)

For installation and assembly of wire and bird netting

Tire width per piece (wire reinforcement) approx.:
25mm

Inner eye width:
6mm

Shaft length:
25 mm (shaft with 21 mm wood thread)

Material thickness:
3.5mm

Materials:
1.4301 stainless steel

Purchase eyebolt 25 x 6 mm. Material 1.4301 stainless steel. Thickness 3.5 mm. Inner width 6 mm. Shaft length 25 mm.

Assembly:
Assembly of the wires (one spring is assembled per section and 2 sleeves)

1. On the eyebolt without spring: the stainless steel cable is passed through the sleeve and then through the eyebolt. Then the rope is pulled through the sleeve again and the resulting loop is tightened to the eye screw. Pinch the sleeve with the pliers – to be on the safe side, pinch in two different places.

2. On the spring: Attach the spring to the eye bolt, pass the other end of the rope through the sleeve, then through the other eye of the spring and back through the sleeve. Pull the end of the rope to tighten the spring, bring the sleeve to the eyebolt, hold and squeeze the sleeve twice. Cut off the rest of the rope just behind the sleeve.

To ensure the best possible protection, stainless steel cables with a diameter of 0.54 mm must be stretched parallel to each other with approximately 3.5 cm intervals.